Viking Range Designer Series Guida di Installazione Scaricare il pdf (Pagina 6)

IINNSSTTAALLLLIINNGG RROOUUGGHH--IINN PPLLAATTEE AANNDD CCOONNNNEECCTTIINNGG DDUUCCTT -- IINNTTEERRNNAALL PPOOWWEERR

((AAllssoo sseeee iinnssttrruuccttiioonnss ssuupppplliieedd wwiitthh vveennttiillaattoorr kkiitt))

1. Attach rough-in plate to studs in the inside, top of hood with four (4) #10-24 nuts provided.

2. Connect ductwork using supplied transition and damper (transition and damper are part of rough-in plate on some

models). Use duct tape to make all joints secure and air tight. In some installations, it is easier to attach transition

to plate before attaching plate to hood.

3. Remove wire box cover. Remove a knockout from the wiring box. Feed 6” of power cable through opening and

attach cable to wiring in wiring box with appropriate connector.

WWAARRNNIINNGG

: MAKE SURE ELECTRICAL SUPPLY IS

OFF.

4. Wire black to black, white to white, and green or bare wire beneath green ground screw. Replace wire box cover.

5. Plug the rough-in plate power cord into the receptacle located on the top side of the light panel.

Top of Hood

Studs

Nuts

Rough-in

Plate

Wire box cover

Nuts

Studs

3-prong power

supply plug-in

2-prong blower plug-in

Receptacles are located

behind and above control

panel

1 2 3 4 5 6 7 8 9 10

Nessun commento

Viking Range Designer Series Guida di Installazione Pagina 6